Examples of Options

Home My Work ('06-'07) My Work II ('08-  ) Accuracy Work Services Frontstrap Options Examples of Options Finishes AR15.com/Heller Project What's New Testimonials About Miller Custom Apparel Guns / Parts for Sale Contact Me Links

sales@millercustom.com

Phone (309)-737-2466

 

 

Here you will see some examples of different options and a brief explanation of them.


This is an example of "Racing Stripe" Arrow Point Flat top and Serration

 

The Slide was treated with a flat topping and serrations, leaving out 2 of the outer lines to create "Rally Stripes" and then bordering the treatment with one last line on both sides.  On this particular slide, I also fluted the slide with a ball end mill to add a little more flare.  Cost - $120


This is an example of Arrow Point Flat Top and Serrations

This slide was treated with Arrow Point Serrations.  You will see there is a difference from the "Racing Stripe" serrations as the lines extend all the way across the flat.  Cost - $120


This is an example of standard Flat Top Serrations

You will see that the flat topping and serrations extends all the way to the muzzle and back to the rear sight.  Cost $100


Staggered Borders

These slides have "lines" that extend from the muzzle on the slide toward the rear of the pistol.  You will see as the lines step down from the top, they end in different lengths and progressively get shorter.  This gives an illusion that the slide gets a little thinner from front to back and adds a special touch of flare.  Cost - $160


Standard "Freedom" Borders

These pistols have the Standard Borders applied.  You will notice the extra staggered lines are omitted so there is only one line extending down the slide where the flats meet the round top.  Some people refer to these as "French Borders" but I like to call them "Freedom Borders."  Cost - $40


Recessed Cocking Serrations

On this pistol, you will see the cocking serrations are quite a bit lower in the slide than normal.  They are machine deeper and a fluted edge are added for appearance.  You can see the process in the first 2 pictures and the final result after finishing in the third.  They add a different look to the gun while giving the same grip and function to the pistol.  Not all pistols can be cut in this fashion.  Existing cuts may not leave proper material for this cut.  Cost - $175


 


More to come - if you have anything you would like to see, email me at sales@millercustom.com



 

Home | My Work ('06-'07) | My Work II ('08-  ) | Accuracy Work | Services | Frontstrap Options | Examples of Options | Finishes | AR15.com/Heller Project | What's New | Testimonials | About Miller Custom | Apparel | Guns / Parts for Sale | Contact Me | Links